CANON IMAGERUNNER IR5000 DRIVER

Photosensitive drum Check the primary charging system; if normal, replace the photosensitive drum. Tablets by Dan Ackerman 8 days ago. The stapler motor M6 is faulty. Is the white background foggy? The Main controller PCB is faulty. F 2 Remove the paper size plate [2], and turn the adjusting screw [3] found in the opening of the paper size plate [2] to adjust the position; then, tighten the two fixing screws [1]. If lines of 32 dots wide are found, the board is normal; otherwise, the board is faulty.

Uploader: Fenrisar
Date Added: 4 June 2006
File Size: 52.95 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 44969
Price: Free* [*Free Regsitration Required]

NO Is the density too low or too high too light or too dark? Correct Correct Wrong Wrong Grid side.

F [1] [2][3] [4] [5] [8] [7] [7] [6]. Actual prices are determined by individual dealers and may vary.

Checking the Environment Sensor 9. Removing the inlet guide base will require adjustment of the position of the inlet guide.

Range of to unit: Search Our Knowledge Base Please enter your question: Mode of Detection The stitcher home position sensor rear does not turn off when the stitch motor imagerynner has been rotated CW for 0. Mode of Detection The clock pulses do not arrive for 2 secs or more after the drum motor drive signal DMFG has been generated.

  LENOVO 0769 FINGERPRINT DRIVER

imageRUNNER 5000

When winding, be sure that the cable metal fixing is inside. Using the Mode 1 Clean the back of the copyboard glass. If images are foggy or high-density areas are faint, correct the F-value table. The sub thermistor TH2 has imxgerunner overheating. Types of Jams Code Type 00xx none 01xx delay jam 02xx stationary jam 0Axx stationary jam at power-on 0Bxx front cover open jam T ff: Mode of Detection The communication between the coin vendor and the main controller PCB has been interrupted.

Decrease the setting of the following in service mode: E Main Cause The various printer board accessories are faulty.

F 2 Move the cassette guide assembly front [4] to the front or the rear to make adjustments. VRs that may be used in the field: Visit the Canon Online Store. Execute shading adjustment in service mode: Mode of Detection When operation starts, as many clocks as needed do not arrive from the delivery motor imagerinner sensor.

Canon imageRUNNER – multifunction printer (B/W) Overview – CNET

Image including halftone to check halftone density Check the following: Caution After electing the appropriate paper size, be sure to turn off and then on the main power switch. AB series Not used. F For other charging assemblies, remove the two lids. Using the Mode 1 Keep both sensors at the point farthest from the paper. Modify your browser’s settings to allow Javascript to execute.

  INTEL FW82801DB ETHERNET CONTROLLER DRIVER

Canon IR 5000/6000 Toner Black

Settings to T; default: Make the selections in service mode, and turn off caonn then on the main power switch: Using the Mode 1 Place sheets of standard white paper 10 sheets min. Mode of Detection The puncher does not leave home position when the punch motor has been driven for msecs.

Please contact your Canon Authorized dealer for all your service needs. F Charging imageeunner rear front Charging wire ReelStud. Caution The following must be executed before initiating auto adjustment in this mode: